Menu Close

USER GUIDE

NOTE: PUT YOUR SAFETY FIRST
Custom in-ear monitors always adhere very well to your ears and provide maximum noise cancellation. There’s no need to raise the volume over safe level, doing so could do more harm than good and lead to irreversable hearing loss.

Due to CIEMs’ noise cancelling nature, don’t use them while participating in traffic or doing any outdoor activities near busy traffic areas.

 

USAGE

Step 1: Attaching cable

Every Itsfit product has recessed sockets that go with our two-pin connection cable. Attach the cable to the sockets carefully until secure.

Step 2: Install tips

Install one in five pairs of tips provide. Slide them onto the noozles and try on your ears. If they don’t feel snug, try another pair.

Step 3: Identify side

Both left and right sides of each pair of monitor is marked with “L” and “R” signs, which can be seen on the back of their shells.
Make sure you wear correctly.

Step 4: Insert & Adjust

Insert the monitors in your ears, gently push and adjust until they’re completely sealed in.

Step 5: Secure & check

Secure the cable behind your ears, along your ears’ curve. Cinch.

And it’s all done. Enjoy your music now.

 


CARING

Store them in the case when not in use. Don’t expose them to water since moisture can damage electrical components inside. Avoid storing them with any hard substances, throwing or dropping them as they can be damaged, crushed or broken.

Step 1: CLEANING

Gently remove wax buld-up near the CIEMs’ canals with the cleaning tool.

Step 2: BRUSHING

Scrub off any debris left with the brush provide in the kit.

Step 3: POLISHING

Use a microfiber cloth or our soft cloth to gently polish the shell.

Step 3: WRAPPING

Cinch the cable near the monitor, then wrap it loosely around your palm.

Step 5: STORING

Store them in the carrying case. Don’t store them together with any hard substances to avoid damage.